Introduction
Art & Design has 3 Epson 3880 ink jet printers for student use
• Location: 34 - 222 Photo Lab (3 printers)
• Students need to supply their own paper unless otherwise notified by your Faculty.
• The 3880 printers are professional quality photographic printers, although they can also be used for graphics work or other non-photo prints.
• In order to achieve highest quality results, specific paper and the correct associated ICC profiles must be used. Epson paper is a safe bet, and Epson profiles are loaded on the connected lab computers and ready to use. Please check with Faculty or the Lab Tech if want to use other paper.
• All ink jet (Photographic) printers through out Art & Design can only be used from a dedicated, directly connected lab work station. They are not available for network printing from other computers.
• Be sure you have enough credit on your PaperCut account to print your job(s)
-
-
Be sure to log into the correct (attached) lab computer.
-
Confirm the LCD display on the top of the printer is lit and says Ready.
-
If the screen is not lit, push the power button (large button to the left), and wait about 1 minute for the printer to start up.
-
-
-
This printer has multiple input trays. Most prints can use the default auto sheet feeder picture here.
-
Verify/open the input and output trays on the printer.
-
Lift the top lid to open the input tray and extend the paper support as needed.
-
Push the front door gently to open the output tray.
-
-
-
Pull gently with both hands to extend the output tray to support your paper as it exits the printer.
-
-
-
Adjust the Left Edge Guide so there is plenty of room to load your paper.
-
-
-
Load your paper, with the printable side up.
-
Adjust the Left Edge Guide so the paper is supported, but not pinched.
-
Printer not ready? Out of Ink? Other problems or questions? See the area tech for assistance.
-